Vault Mitered Handlebars For Harley Davidson
- Works with throttle by wire (TBW) and cable controls
- 1.25″ Diameter tubing with 1″ at the grips and center clamp section
- Slotted at the grips and clamping section for internal wiring
- 5.25″ Wide center section for use with 3.5″ riser bolt spacing
- Fits Harley Davidson and custom motorcycles
- Height: 8″ | Pullback: 7″ | Width: 31″ | Bottom width: 11″
*Does not fit models with a batwing fairing
*All measurements are with the hand grip section parallel to the ground
Made in the USA
Lonnie Hull –
Beautiful bars!!!
Henry Wassman –
I’ll send photos when the bike is done!!!👍🏽