Twisted Choppers Rear for Axle Weld-On Hardtail Sportster Frame
When you’re running a Twisted Choppers weld-on hardtail conversion on your Sportster, the rear axle needs to be matched precisely to your frame width and wheel setup — and this axle is built for exactly that application. It drops in where the factory axle was provided and gives you the right fitment for stock, 200mm, and 250mm tire configurations.
Key Features
- Designed specifically for Twisted Choppers weld-on hardtail Sportster frames
- Available in 3/4″ and 1″ axle diameters to accommodate different wheel hub configurations
- Machined to accept a retaining ring for positive axle retention and safety
- Zinc plated for corrosion resistance and a clean finished appearance
- Made in the USA from 1144 stress-proof steel
Technical Specifications
- Available Axle Diameters: 3/4″ and 1″
- Wheel Size Compatibility: Stock 150mm, 200mm, 250mm
- Retention Feature: Machined groove for retaining ring
- Finish: Zinc plated
- Material: 1144 stress-proof steel
- Origin: Made in the USA
Fitment Notes
- Designed exclusively for Twisted Choppers weld-on hardtail Sportster frames
- Axle size selection is based on the outside measurement of your frame’s axle plates — your frame width must fall within the minimum and maximum range listed for each wheel size
- Not all wheel size and axle diameter combinations are available — refer to the Fitment tab for valid combinations
- Review the Fitment tab for frame width requirements and complete size selection details
Reviews
There are no reviews yet