S&S Cycle CNC-Machined Kicker Side Cover for Custom S&S Big Twin Kickstarter Builds

S&S Cycle CNC-Machined Kicker Side Cover for Custom S&S Big Twin Kickstarter Builds

Building a kickstarter-equipped Big Twin demands components that look the part without sacrificing modern reliability. This kicker side cover captures the period-correct appearance of factory castings while incorporating engineering improvements that eliminate common failure points. The result is a cover that fits the era and outlasts it.

Key Features

• Period-accurate exterior matching factory Big Twin casting appearance, including faithfully reproduced casting imperfections
• 100% CNC-machined to S&S quality standards
• Reinforced kicker boss area with single shaft bushing for improved oiling and stability
• Clearanced for large throw-out bearing and kicker shaft bushing
• Precision-reamed clutch arm bushings ready for installation
• Stealth small-diameter kicker shaft seal virtually invisible from the exterior
• Accepts stock hardware and filler plug
• Includes gasket for direct installation

Technical Specifications

• Construction: 100% CNC-machined
• Hardware Compatibility: Accepts stock hardware and filler plug
• Kicker Shaft Seal: Small-diameter, low-profile design
• Included: Gasket for installation

Fitment Notes

• For use in custom S&S Big Twin kickstarter builds only
• Confirm crankcase and transmission configuration compatibility before ordering
• Review the Fitment tab for complete compatibility information