NAMZ Handlebar Wiring Extension 8 Inch CAN Bus for 2011-2022 Harley-Davidson Softail Dyna Sportster
Modern Harley-Davidson CAN bus models demand an extension harness that understands the electronics as well as the wiring — and this kit was built specifically for that generation. Every switch function and CAN circuit stays fully operational after the handlebar swap, so the bike runs exactly as it left the factory, just with a better set of bars on top.
Key Features
- Engineered specifically for Harley-Davidson Controller Area Network (CAN bus) equipped models — extends the CAN circuit along with all switch harness wiring
- Complete kit — everything needed to extend OEM handlebar switch harnesses on both sides without cutting or splicing factory wiring
- OEM color-matching wire and OEM connectors maintain factory-correct appearance and compatibility
- Male and female Molex terminals pre-installed on both harness ends for direct plug-in fitment
- MIL-SPEC machine crimped terminals engineered for vibration-resistant, long-term reliability
- Harness professionally loomed in polyolefin heat shrink for a clean, protected finish
- Made in the U.S.A.; hand assembled in Pennsylvania
Technical Specifications
- Extension Length: 8 inches
- System Compatibility: Harley-Davidson CAN bus (Controller Area Network) equipped models
- Terminal Type: Molex, male and female, pre-installed on both harness ends
- Terminal Crimp Standard: MIL-SPEC machine crimped
- Wire Type: OEM color-matching
- Loom Protection: Polyolefin heat shrink
- Units: Pair (left and right harnesses included)
- Country of Origin: United States
- Assembly Location: Pennsylvania
Fitment Notes
- Fits 2011-up Softail, 2012-2017 Dyna, and 2014-2022 Sportster (XL) models equipped with CAN bus wiring
- Does NOT fit V-Rod models — V-Rod uses a different handlebar switch harness architecture
- Does NOT fit pre-2011 Softail, pre-2012 Dyna, or pre-2014 Sportster models — those require the NAMZ D-series or M-series extension kits
- Does NOT fit Sportster S (RH1250S) 2021-up — that model uses a different wiring system
- For 2014-up FL Touring (Bagger) CAN bus models, verify fitment before purchase — Touring models may require the NAMZ MB-series; consult the Fitment tab or contact us to confirm
- Electronic Throttle-by-Wire (TBW) extensions are sold separately for applicable models
- Front turn signal extensions are not included and must be purchased separately if required
- Review the Fitment tab for the complete year and model breakdown
Reviews
There are no reviews yet